Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Explorer Base, 2.0 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Starting System) >> Diagnosis And Testing >> Starting System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this service information assumes a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to DIAGNOSTIC METHODS for information about these practices.

  1. Verify the customer concern by operating the starting system.
  2. Check the battery condition and state of charge. REFER to BATTERY CONDITION TEST .
  3. Remove the accessory drive belt. REFER to REMOVAL AND INSTALLATION . Verify the crankshaft and each of the components driven by the accessory drive belt rotate and are not seized or damaged.
  4. If any aftermarket accessories have been added to the vehicle, make sure they are properly wired.
  5. If an obvious cause for an observed or reported concern is found, correct the cause before proceeding.
scientia non olet · About Mike's Workshop Manuals