Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Explorer Base, 2.0 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Engine System - General Information) >> General Procedures >> Piston Pin Bore Diameter

Piston Pin Bore Diameter

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to the appropriate Engine article for the specification.
  1. NOTE: Piston and piston pins are a matched set and should not be interchanged.

    Measure the piston pin bore diameter in 2 directions on each side. Verify the diameter is within specification.

    Fig 1: Identifying Piston Pin Bore Diameter Measuring Directions
    G06064074Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals