Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Explorer Base, 2.0 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Controls - Powertrain DTC Charts & Descriptions (Diesel)) >> Diagnostic Trouble Code (DTC) Charts And Descriptions >> DTC P264F: Engine Serial Number Not Programmed Or Incompatible

DTC P264F: Engine Serial Number Not Programmed Or Incompatible

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
DTC P264F: ENGINE SERIAL NUMBER NOT PROGRAMMED OR INCOMPATIBLE

Description:  This DTC sets when the PCM does not receive a valid engine serial number during reprogramming.
Possible Causes: 
  • Engine serial number corrupted during vehicle identification (VID) reprogramming
  • PCM replacement
  • Damaged PCM
Diagnostic Aids:  The VID block must be programmed. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming VID Block. If the PCM does not allow reprogramming of the VID block, reflashing of the PCM is required.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC in this table.
Refer to the appropriate articles related to the description, possible causes and diagnostic aids.
scientia non olet · About Mike's Workshop Manuals