Removal and Installation
WARNING: This page is about a different car, the 2013 Lincoln MKX and 2013 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the Fuel Pump Control Module (FPCM) electrical connector.
- Remove the 2 FPCM bolts.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
NOTE:
Do not overtighten the fasteners or damage to the module may occur.