Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Econoline Base, Van Cargo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Suspension System - General Information) >> General Procedures >> Toe Adjustment

Toe Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Start the engine and center the steering wheel.
  2. Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
  3. Loosen the steering linkage adjusting sleeve nuts.
    Fig 1: Locating Steering Linkage Adjusting Sleeve Nuts
    G06136763Courtesy of FORD MOTOR CO.
  4. Rotate the adjusting sleeves to obtain the correct toe setting.
  5. Position both adjusting sleeve clamp openings downward within 45 degrees of vertical. Tighten the nuts to 55 Nm (41 lb-ft).
    Fig 2: Positioning Adjusting Sleeve Clamp
    G06136764Courtesy of FORD MOTOR CO.
  6. Verify the toe settings and adjust as necessary.
scientia non olet · About Mike's Workshop Manuals