Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Econoline Base, Van Cargo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (HVAC - Climate Control System - General Information And Diagnostics) >> General Procedures >> Refrigerant Oil Adding >> Adding Refrigerant Oil After Multiple Component Replacement After A/C System Contamination

Adding Refrigerant Oil After Multiple Component Replacement After A/C System Contamination

WARNING: This page is about a different variant/trim than selected.
NOTE: This refrigerant oil adding method is to be used when a new A/C compressor, suction accumulator or receiver drier and evaporator core orifice or TXV have been installed due to system contamination and the A/C system has been flushed.
  1. If the new A/C compressor is shipped with a new clutch and pulley already installed, remove the shipping caps and rotate the new A/C compressor shaft 6 to 8 revolutions while collecting the oil in a clean measuring cup.
  2. Add 60 ml (2 fl oz) directly to the new A/C compressor suction port.
  3. Inject the total vehicle PAG oil capacity minus 60 ml (2 fl oz) to the low-side service port during system charging. For the total PAG oil capacity specification, refer to the SPECIFICATIONS TABLE  .
scientia non olet · About Mike's Workshop Manuals