Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Econoline Base, Van Cargo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine System - General Information -- E-Series) >> Diagnosis And Testing >> Powertrain/Drivetrain Mount Neutralizing

Powertrain/Drivetrain Mount Neutralizing

WARNING: This page is about a different variant/trim than selected.
NOTE: Refer to the appropriate information and procedure for special instructions on loosening and tightening mount fasteners.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Loosen, but do not remove, the powertrain/drivetrain mount fasteners.
  3. Lower the vehicle.
    4. NOTE: Do not twist or strain the powertrain/drivetrain mounts or damage to the mounts may occur.
  4. Start the vehicle and move it in forward 0.6-1.2 m (2-4 ft). Then move the vehicle in reverse the same distance.
  5. Raise and support the vehicle.
  6. Tighten the powertrain/drivetrain mount fasteners.
  7. Lower the vehicle.
  8. Test the system for normal operation.
scientia non olet · About Mike's Workshop Manuals