Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2011 >> Taurus Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 913 (Supplemental Inflatable Restraint System) >> Removal And Installation >> Restraints Control Module (RCM) >> Removal And Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carry out the steps necessary to prepare for programmable module installation (PMI). For additional information, refer to MODULE CONFIGURATION article.
  2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  in the General Procedures portion of this section.


  1. Disconnect the small RCM electrical connector.
  2. Disconnect the large RCM electrical connector.
    Fig 1: Disconnecting RCM Electrical Connector
    GF0008858Courtesy of FORD MOTOR CO.
    • Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
    • Pull out and disconnect the RCM electrical connector.
  3. Remove the 3 bolts and the RCM.
scientia non olet · About Mike's Workshop Manuals