Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2011 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Engine Cooling System) >> General Procedures >> Cooling System Flushing >> Material

Cooling System Flushing: Material

WARNING: This page is about a different car, the 2010 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS

Item Specification
Motorcraft® Premium Gold Engine Coolant with Bittering Agent (bittered in US only)
VC-7-B (US); CVC-7-A (Canada); or equivalent (yellow color)		 WSS-M97B51-A1
Premium Cooling System Flush
VC-1		 ESR-M14P7-A
    WARNING: Always allow the engine to cool before opening the cooling system. Do not unscrew the coolant pressure relief cap when the engine is operating or the cooling system is hot. The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may result in serious personal injury.
  1. Once pressure is released, remove the pressure relief cap/radiator cap.
  2. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  3. Remove the coolant thermostat. For additional information, refer to THERMOSTAT AND THERMOSTAT HOUSING - EXPLODED VIEW , THERMOSTAT - 4.0L SOHC , THERMOSTAT - 4.6L (3V)  or THERMOSTAT - 5.4L (4V) .
  4. Install the coolant hose connection without the thermostat.
    5. NOTE: Refer to the cooling system flusher manufacturer's operating instructions for specific vehicle hook-up.
  5. Using an appropriate cooling system flusher, flush the engine and radiator. Use Premium Cooling System Flush or equivalent meeting Ford specification ESR-M14P7-A. Always flush the cooling system with water thoroughly after using the VC-1 flush and prior to filling the cooling system with the same coolant that was present in the system. Do not mix coolant types.
  6. Install the thermostat. For additional information, refer to THERMOSTAT AND THERMOSTAT HOUSING - EXPLODED VIEW  and THERMOSTAT - 4.0L SOHC , THERMOSTAT - 4.6L (3V)  or THERMOSTAT - 5.4L (4V) .
  7. Backflush the heater core. For additional information, refer to HEATER CORE BACKFLUSHING .
  8. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About Mike's Workshop Manuals