Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2011 >> Flex SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 1922 (Climate Control System) >> Removal And Installation >> Blower Motor Speed Control >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the RH scuff plate trim panel from the RH lower A-pillar trim panel.
  2. Remove the RH lower A-pillar trim panel.
  3. Remove the 2 RH lower instrument panel insulator pin-type retainers and the RH lower instrument panel insulator.
  4. Disconnect the blower motor speed control electrical connector.
  5. Remove the 2 blower motor speed control screws.
  6. Remove the blower motor speed control.
  7. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals