Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2010 >> RV Cutaway 6.0 P >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Glow Plug System - 6.0L Diesel Models -- E-Series >> Removal And Installation >> Glow Plug Module >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Remove the 2 nuts for the glow plug module.
    • To install, tighten to 8 Nm (71 lb-in).
      Fig 1: Locating Glow Plug Module With Nuts
      G06139845Courtesy of FORD MOTOR CO.
  4. Position the glow plug module and disconnect the glow plug module electrical connectors. Remove the glow plug module.
    Fig 2: Locating Glow Plug Module Electrical Connectors
    G06139846Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals