Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2010 >> Fusion Hybrid >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls (Hybrid) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
  2. Remove the cowl panel grille. For additional information, refer to COWL PANEL GRILLE .
  3. Disconnect the 3 PCM electrical connectors.
  4. Remove the PCM.
    • Remove the lower bolt and the upper PCM bracket bolt.
  5. Remove the bolt and the bracket from the PCM.
scientia non olet · About Mike's Workshop Manuals