Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2010 >> Focus S, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Automatic Transaxle/Transmission >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

  1. NOTE: Apply a light coat of clean transmission fluid to the O-ring before installation.

    Install the OSS  sensor.

    • Tighten to 10 Nm (89 lb-in).
    • Connect the electrical connector.
    Fig 1: Locating OSS Sensor
    G06292821Courtesy of FORD MOTOR CO.
  2. Lower vehicle.
  3. Check the transmission fluid level and add transmission fluid as necessary.
  4. Start the engine and move the transaxle range selector lever through all gear positions.
scientia non olet · About Mike's Workshop Manuals