Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Upload the PAM configuration information to the scan tool. For additional information, refer to PMI in MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
- Remove the LH rear seat bolster. For additional information, refer to SEAT SYSTEM - SEATS -- FUSION, MILAN & MKZ article.
- Remove the 2 screws and the PAM.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
- Download the PAM configuration information. For additional information, refer to MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
NOTE:
Module configuration is only required if a new Parking Aid Module (PAM) is being installed.