Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2010 >> Explorer 4.6 8, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Handles, Locks, Latches And Entry Systems >> General Procedures >> Autolock and Auto-Unlock Programming >> Autolock Programming Using the Ignition Lock Cylinder

Autolock Programming Using the Ignition Lock Cylinder

  1. Close all doors and windows.
  2. Confirm that the ignition key is OFF.
  3. NOTE: Steps 5 through 9 must be carried out within 30 seconds.

    Turn the ignition key from OFF to RUN.

  4. Press the door lock control switch UNLOCK button 3 times.
  5. Turn the ignition key from RUN to OFF.
  6. Press the door lock control switch UNLOCK button 3 times.
  7. Turn the ignition key from OFF to RUN.
  8. Verify the horn chirps. This indicates the enable/disable mode and now is ready to accept program changes.
  9. Press the door lock control switch UNLOCK button then the LOCK button 1 time to command the module to toggle the autolock/relock feature.
  10. Verify that the horn chirps. There should be 1 chirp indicating that autolock/relock feature has been disabled. If 1 chirp is heard, followed by a longer sound of the horn, the autolock/relock feature has just been enabled.
  11. Turn the key to the OFF position or wait 2 minutes to exit the enable/disable mode.
  12. Verify that the horn chirps once to indicate that a feature has been changed and that autolock/relock has been toggled.
scientia non olet · About Mike's Workshop Manuals