Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2010 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Electronic Engine Controls - 2.5L (Except Hybrid) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

  1. Install the PCM cowl seal.
  2. Install the PCM and the 2 bolts.
    • Tighten to 8 Nm (71 lb-in).
  3. Connect the 3 PCM electrical connectors.
  4. Attach the wiring harness retainer to the cowl stud bolt.
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
  6. Reprogram the PATS  . Carry out the Parameter Reset procedure. For additional information, refer to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET .
  7. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About Mike's Workshop Manuals