Removal and Installation

All vehicles 

1. Remove the 3 bolts and position the degas bottle aside.
   • To install, tighten the bolts to 10 Nm (89 lb-in).
   Fig 1: Locating Degas Bottle Bolts

   Courtesy of FORD MOTOR CO.

   Vehicles equipped with 6.0L engine or Hydro-Boost® 

2. Remove the Air Cleaner (ACL). For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .

   All vehicles 

3. Disconnect the ABS module electrical connector.
   • Release the lock tab.
   • Pull the connector from the module.
   Fig 2: Locating ABS Module Electrical Connector

   Courtesy of FORD MOTOR CO.
4. Remove the 4 screws and the ABS module.
   • To install, tighten the screws to 5 Nm (44 lb-in).
5. To install, reverse the removal procedure.

• For vehicles equipped with Roll Stability Control (RSC®), carry out the IVD Initialization sequence. Follow the scan tool directions.