Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Fusion S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission External Controls) >> Removal And Installation >> Selector Lever >> Removal

Selector Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the center console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  2. Disconnect the selector lever cable end from the selector lever.
    3. Fig 1: Locating Selector Lever Cable End
    GF0029897Courtesy of FORD MOTOR CO.
  3. Release the tab on the selector lever cable and remove it from the selector lever housing.
    4. Fig 2: Locating Selector Lever Cable Locking Tabs
    GF0029898Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    5. Fig 3: Locating Electrical Connector
    GF0029899Courtesy of FORD MOTOR CO.
  5. Remove the 4 nuts and remove the selector lever.
    6. Fig 4: Locating Nuts
    GF0029900Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals