Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Fusion S, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Manual Transmission External Controls System) >> Removal And Installation >> Gearshift Lever >> Installation

Gearshift Lever: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the gearshift lever assembly in the vehicle.
  2. Install the 4 gearshift lever nuts.
    • Tighten to 23 Nm (17 lb-ft).
  3. Connect the selector cable.
  4. Connect the shift cable.
    • Tighten the nut to 9 Nm (80 lb-in).
  5. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
  6. Position the console and install the 2 console screws to the shifter base.
  7. Install the 2 front console center bolts and then install the 2 rear side console bolts.
scientia non olet · About Mike's Workshop Manuals