Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Flex SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 1601 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Stability Control Sensor Cluster >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When installing a new stability control sensor cluster, the ABS module must be calibrated. Follow the scan tool directions for the calibration procedures.
  1. Remove the front floor console. For additional information refer to INSTRUMENT PANEL AND CONSOLE article.
  2. Disconnect the stability control sensor cluster electrical connector.
  3. Remove the stability control sensor cluster electrical harness retainers and position aside.
  4. Remove the 2 stability control sensor cluster bracket bolts and the stability control sensor cluster.
    • To install, tighten to 12 Nm (106 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals