Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Edge SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (MULTIFUNCTION Electronic Modules System) >> Removal And Installation >> Driver Seat Module (DSM) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver seat. For additional information, refer to SEATING article.
  2. If equipped, position the dual climate control seat module (DCSM) aside.
  3. Disconnect the driver seat module (DSM) electrical connectors.
  4. Using a drill, remove the 2 rivets and the DSM.
  5. To install, reverse the removal procedure.
    • Use the special tool to install the 2 rivets.
scientia non olet · About Mike's Workshop Manuals