Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Edge SEL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1700 (Information System & Entertainment System) >> Removal And Installation >> Rear Entertainment Module (RETM) >> Removal

Rear Entertainment Module (RETM): Removal

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Programmable Module Installation (PMI) only needs to be carried out if the Rear Entertainment Module (RETM) is being replaced.
  1. Upload the RETM configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
    2. NOTE: Open the display.
  2. Remove the 4 screws.
  3. Remove the RETM.
    • Pull down on the sides of the RETM to disengage the clips from the bracket.
    • Using a suitable tool, push the rear most U-hook forward and release the U-hooks.
    • Hang the RETM on the J-hooks and disconnect the electrical connector.
    • Remove the RETM from the J-hooks.
scientia non olet · About Mike's Workshop Manuals