Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Edge SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1460 (Acceleration Control System) >> Removal And Installation >> Accelerator Pedal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the accelerator pedal sensor electrical connector.
  2. Remove the 3 accelerator pedal and sensor bolts.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Remove the accelerator pedal and sensor assembly.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals