Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Edge SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1433 (HVAC Climate Control System - General Information And Diagnostics) >> General Procedures >> Refrigerant Oil Adding >> Adding Refrigerant Oil After Multiple Component Replacement After A/C System Contamination

Adding Refrigerant Oil After Multiple Component Replacement After A/C System Contamination

WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This refrigerant oil adding method is to be used when a new A/C compressor, suction accumulator or receiver drier and evaporator core orifice or TXV have been installed due to system contamination and the A/C system has been flushed.
NOTE: Service A/C compressors are shipped without refrigerant oil.
  1. Add 60 ml (2 fl oz) directly to the new A/C compressor suction port.
  2. Inject the total vehicle PAG oil capacity minus 60 ml (2 fl oz) to the low-side service port during system charging. For the total PAG oil capacity specification, refer to the SPECIFICATIONS  table.
scientia non olet · About Mike's Workshop Manuals