Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Edge SE, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - Vehicle Dynamic Systems >> Removal And Installation >> Wheel Speed Sensor - Rear >> Removal And Installation

Removal And Installation

  1. Remove the wheel and tire. For additional information, refer to WHEELS & TIRES article.
  2. Disconnect the wheel speed sensor electrical connector.
    3. NOTE: It is not necessary to remove the harness routing brackets.
  3. Disconnect the wheel speed sensor harness from the brackets.
  4. Disconnect the push pin fasteners.
  5. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 7 Nm (62 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals