Rear Entertainment Module (RETM): Installation
WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
- Hang the RETM on the J-hooks.
- Connect the electrical connector.
- Remove the RETM from the J-hooks.
- Align the left side guide pin with the left side locating hole.
- Lift up the right side of the RETM and engage the U-hooks.
- Install the 4 screws.
- Push on the left and right sides of the RETM to engage the clips.
- If a new RETM is being installed, download the RETM configuration from the scan tool. For additional information, refer to MODULE CONFIGURATION .
NOTE:
Tilt the RETM
, as necessary, to align it correctly.