Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2009 >> Edge Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1456 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Stability Control Sensor Cluster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front floor console rear storage compartment. For additional information, refer to the front floor console exploded view in INSTRUMENT PANEL AND CONSOLE .
  2. Disconnect the stability control sensor cluster electrical connector.
  3. Disconnect the stability control sensor cluster electrical harness retainers and position aside.
  4. Remove the 2 stability control sensor cluster bracket bolts and the stability control sensor cluster.
    • To install, tighten to 12 Nm (106 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals