Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2008 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal And Installation

Removal And Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Disconnect the 3 wheel speed sensor harness pin-type retainers.
  4. Disconnect the 2 wheel speed sensor grommet retainers from the brake hose clips.
  5. Remove the wheel speed sensor bolt.
    • To install, tighten to 15 Nm (133 lb-in).
  6. Remove the wheel speed sensor and harness assembly.
  7. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals