Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2008 >> Escape Hybrid, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System - 2.3L - (Hybrid) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the stud bolts.
    • Tighten to 6 Nm (53 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Attach the wiring harness retainer to the PCM stud bolt and install the nut.
    • Tighten to 6 Nm (53 lb-in).
  4. Attach the ground strap to the PCM stud bolt and install the nut.
    • Tighten to 6 Nm (53 lb-in).
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
scientia non olet · About Mike's Workshop Manuals