Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2008 >> Escape Base, 3.0 1, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Electronic Engine Control System - 2.3L - (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  2. Remove the nut and the wiring harness retainer from the powertrain control module (PCM) stud bolt.
  3. Remove the nut and the ground strap from the PCM stud bolt.
  4. Disconnect the 3 PCM electrical connectors.
  5. Remove the 2 stud bolts and the PCM.
scientia non olet · About Mike's Workshop Manuals