Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2008 >> Escape Base, 2.3 Z, AWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System - 2.3L - (Except Hybrid) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

  1. Install the PCM cowl seal.
  2. Install the PCM and the 2 stud bolts.
    • Tighten to 6 Nm (53 lb-in).
  3. Connect the 3 PCM electrical connectors.
  4. Position the wiring harness and install the PCM stud bolt nut.
    • Tighten to 6 Nm (53 lb-in).
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  6. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
scientia non olet · About Mike's Workshop Manuals