Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Taurus SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Acceleration Control System) >> Removal And Installation >> Accelerator Pedal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Sable and 2005 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the accelerator pedal cable.
    1. Position the accelerator pedal to relieve tension on the accelerator cable.
    2. Depress the tabs on the accelerator pedal retaining pin and disconnect the cable.
    Fig 1: Disconnecting Accelerator Pedal Cable
    G03957667Courtesy of FORD MOTOR CO.
  2. Remove the accelerator pedal.
    • Remove the nuts.
    • Remove the accelerator pedal assembly.
    Fig 2: Removing Accelerator Pedal Nuts - With Torque Specification
    G03957668Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals