Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Taurus SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Electronic Engine Control System) >> Removal And Installation >> Throttle Position (TP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Sable and 2005 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the throttle position (TP) sensor electrical connector.
    Fig 1: Disconnecting Throttle Position Sensor Electrical Connector
    G03956577Courtesy of FORD MOTOR CO.
  3. Remove the screws and the TP sensor.
    Fig 2: Removing Screws And Throttle Position Sensor - With Torque Specification
    G03956578Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals