Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Focus ST >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump Pulley >> Installation

Power Steering Pump Pulley: Installation

    NOTE: Make sure the pulley is flush with the end of the power steering pump shaft.
  1. Using the special tool, install the power steering pump pulley.
    2. Fig 1: Installing Power Steering Pump Pulley
    GF0025593Courtesy of FORD MOTOR CO.
  2. Rotate the tensioner clockwise and position the accessory drive belt on the power steering pump pulley.
  3. Position the accessory drive belt splash shield and install the 2 bolts.
    • Tighten to 9 Nm (80 lb-in).
scientia non olet · About Mike's Workshop Manuals