Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Focus SES, 2D Hatchback, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Removal

Output Shaft Speed (OSS) Sensor: Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Place a drain pan beneath the output shaft speed (OSS) sensor.
  3. Remove the OSS sensor.
    • Disconnect the electrical connector.
    • Remove the bolt.
    • Inspect the OSS bore.
    4. Fig 1: Locating Electrical Connector
    GF0029802Courtesy of FORD MOTOR CO.
  4. Inspect the O-ring seal for nicks or cuts; install a new O-ring if necessary.
    5. Fig 2: Locating O-Ring Seal
    GF0029803Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals