Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Focus SE, 4D Hatchback, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamic Systems >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal And Installation

Removal And Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  3. Remove the wheel speed sensor bolt.
    • To install, tighten to 9 Nm (80 lb-in).
  4. Disconnect the wheel speed sensor wiring harness electrical connector.
    • Remove the wiring harness from the clips.
  5. Remove the wheel speed sensor.
  6. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals