Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Edge SEL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1096 (HVAC Control System) >> Removal And Installation >> Blower Motor Speed Control >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the glove compartment.
  2. Disconnect the blower motor speed control electrical connector.
  3. Remove the 2 blower motor speed control screws.
    • To install, tighten to 3 Nm (27 lb-in).
  4. Remove the blower motor speed control.
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals