Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Edge SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Cruise Control System) >> Diagnostic Tests >> Speed Control >> Pinpoint Tests >> Pinpoint Test D: Flash Code 2 - Stoplamp Switch Circuit Failure >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

When the brake pedal and the clutch pedal (if equipped) are both released, a signal voltage from the speed control actuator routes to ground through the stoplamp switch. When the brake pedal is applied, voltage is routed to the speed control actuator through circuit CCB15 (BN/GN). This voltage signals the speed control actuator to disengage the speed control. When the clutch pedal (if equipped) is pressed, the clutch pedal position (CPP) switch opens, causing the speed control actuator to disengage the speed control.

Possible Causes

scientia non olet · About Mike's Workshop Manuals