Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Disconnect the throttle position (TP) sensor electrical connector.
- Remove and discard the 2 bolts and the TP sensor.
- To install, tighten to 3 Nm (27 lb-in).
- To install, reverse the removal procedure.
- Install a new TP sensor and screws.
CAUTION:
Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws 1 to 2 full turns using a hand tool, and then use a suitable high speed driver to complete the removal.
CAUTION:
Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
CAUTION:
Do not use a high speed driver to install the new screws or damage to the TP sensor can occur.
NOTE:
When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body (TB).