Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Edge SEL Plus, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid) >> DTC Diagnosis >> P0135 - O2 Heater Circuit (Bank 1, Sensor 1)

P0135 - O2 Heater Circuit (Bank 1, Sensor 1)

P0135 - O2 HEATER CIRCUIT (BANK 1, SENSOR 1)

Description:  During testing the heated oxygen sensor (HO2S) heaters are checked for open and short circuits and excessive current draw. The test fails when the current draw exceeds a calibrated limit or an open or short circuit is detected.
Possible Causes: 
  • Vacuum hose disconnected on exhaust gas recirculation (EGR) system module (ESM) applications
  • Short to VPWR in the harness or HO2S
  • Water in the harness connector
  • Open VPWR circuit
  • Open GND circuit
  • Low battery voltage
  • Corrosion or incorrect harness connections
  • Damaged HO2S heater
Diagnostic Aids:  Check the HO2S electrical connector for damage, corrosion, and water intrusion.
Damaged HO2S heater.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All refer to PINPOINT TEST DW .
scientia non olet · About Mike's Workshop Manuals