Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Edge SEL Plus, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Accessories Control Systems >> Remote Convenience System >> General Procedures >> Universal Transmitter Programming >> Training a Garage Door Opener Equipped With "Rolling Codes"

Training a Garage Door Opener Equipped With "Rolling Codes"

  1. Program the hand-held transmitter to the universal transmitter.
  2. Train the garage door opener receiver to recognize the universal transmitter.
    1. Remove the cover panel from the garage door opener receiver.
    2. Locate the training button on the garage door opener receiver. Location and color of the button may vary by garage door opener manufacturer. Refer to the garage door opener instruction manual.
    3. Press the training button on the garage door opener receiver for 1-2 seconds.
    4. Press the programmed universal transmitter button for as long as the universal transmitter red indicator flashes (1-2 seconds). Release the button and press the button to confirm that the universal transmitter is trained to the receiver.
    5. The garage door opener should recognize the universal transmitter.
scientia non olet · About Mike's Workshop Manuals