Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2007 >> Edge SE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Cruise Control System) >> Diagnostic Tests >> Speed Control >> Pinpoint Tests >> Pinpoint Test H: The Speed Control Switch Is Inoperative >> Pinpoint Test H: The Speed Control Switch Is Inoperative

Pinpoint Test H: The Speed Control Switch Is Inoperative

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. H1 CHECK THE SPEED CONTROL SWITCHES 
    • Disconnect: Speed Control Actuator C122
    • Measure the resistance between the speed control actuator C122-5, circuit VES10 (WH), harness side and the speed control actuator C122-6, circuit RES08 (GN/BN), harness side while pressing the speed control switches as follows:
      Switch Position Resistance Value (in Ohms)
      OFF Less than 5
      ACCEL/SET 646-704
      COAST 114-126
      RESUME 2,090-2,310
      No switch pressed Greater than 10,000
    • Are the speed control switch resistance values OK?  
    1. YES  : INSTALL a new speed control actuator. REFER to Speed Control Actuator . TEST the system for normal operation.
    2. NO  : INSTALL a new speed control switch. REFER to Speed Control Switch . TEST the system for normal operation.
scientia non olet · About Mike's Workshop Manuals