Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2006 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System >> Removal And Installation >> Speed Control Switch >> Removal and Installation

Removal and Installation

  1. Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
    NOTE: Carefully grasp and pull the edges to remove the steering wheel spoke finish panels.
  2. If equipped, remove the steering wheel spoke finish panels.
    NOTE: Using a small, flat-bladed screwdriver, gently pry up the speed control switches from the steering wheel, beginning at the outer edge. Use care not to damage the steering wheel.
  3. Remove the speed control switches.
    • Disconnect the electrical connectors.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals