Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2006 >> Fusion S, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle/Transmission - FNR5 >> In-Vehicle Repair >> Intermediate Shaft Speed Sensor >> Removal

Intermediate Shaft Speed Sensor: Removal

  1. Disconnect the intermediate shaft speed sensor electrical connector.
    Fig 1: Locating Intermediate Shaft Speed Sensor Electrical Connector
    G04681805Courtesy of FORD MOTOR CO.
  2. Remove the bolt and the intermediate shaft speed sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    • Check the sensor bore.
    • Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.
      Fig 2: Locating Intermediate Shaft Speed Sensor Bolt
      G04681806Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals