Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2006 >> Crown Victoria Base, 4.6 W >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal And Installation >> Anti-Lock Brake System (ABS) Module >> Removal and Installation

Removal and Installation

  1. Remove the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Disconnect the anti-lock brake system (ABS) module electrical connector.
  4. Disconnect the hydraulic control unit (HCU) pump motor electrical connector.
    5. NOTE: Care must be taken when removing the module from the hydraulic control unit (HCU).
  5. Remove the ABS module.
    • Remove the screws in the sequence shown.
    • To install, tighten to 3 Nm (27 lb-in).
      Fig 1: Identifying Removing Sequence Of Screws
      G04583220Courtesy of FORD MOTOR CO.
    6. NOTE: Make sure that the ABS module-to-HCU gasket surfaces are clean and that the gasket is correctly installed.
  6. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals