Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2005 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Safety Belt System >> General Procedures >> Replacement of the Weld Nut and Reinforcement

Replacement of the Weld Nut and Reinforcement

    NOTE: The following is for Coupe, Front and Rear, and Convertible rear only.
    NOTE: If the safety belt anchor nuts or reinforcements are stripped or missing, a new nut/reinforcement plate must be installed.
  1. Expose the suspect anchor point.
  2. Drill out two 8-mm (5/16-inch) diameter access holes adjacent to the weld nut clearance hole.
  3. Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
  4. Use MIG wire feed welder and plug weld a 7/16 inch weld nut and standard washer in place at the two 8-mm (5/16-inch) holes.
  5. Metal finish as necessary.
  6. Install the restraint system.
  7. Carry out the Functional Test. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About Mike's Workshop Manuals