Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2005 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Fuel System & Engine Control System - 4.6L (3V)) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
NOTE: The fuel pump driver module (FPDM) is located in the spare tire stowage compartment.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT & CONNECT .
  2. Disconnect the FPDM electrical connector.
  3. Remove the 2 bolts and the FPDM.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals