Removal and Installation

WARNING: This page is about a different car, the 2006 Lincoln Navigator and 2006 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When installing a new module, it must be calibrated and configured (either by download/upload or uploading the as-built data method).

CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
Disconnect the anti-lock brake system (ABS) module electrical connector.

Fig 1: Identifying Anti-Lock Brake System Module Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the 3 bolts and the ABS module.
- To install, tighten to 2 N.m (18 lb-in).
To install, reverse the removal procedure.