Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2005 >> Excursion 5.4 L, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Four-Wheel Drive Systems) >> Removal And Installation >> Four-Wheel Drive (4WD) Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Prior to removal of the four-wheel drive (4WD) control module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Open and lower the glove box compartment.
  3. Disconnect the connectors from the 4WD module.
    Fig 1: Disconnecting Connectors From 4WD Module
    G03909618Courtesy of FORD MOTOR CO.
  4. Remove two nuts, one bolt and the 4WD module.
    Fig 2: Removing Four-Wheel Drive Control Module
    G03909619Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals