Removal and Installation

Remove the hydraulic control unit (HCU). Refer to HYDRAULIC CONTROL UNIT .

NOTE: The ABS module cannot be repaired, install a new ABS module.

Fig 1: Removing Bolts

Courtesy of FORD MOTOR CO.

Remove the bolts.

CAUTION: When the ABS module is separated from the HCU, the motor terminals and the valve stems will be exposed. Protect the terminals and the valve stems from damage.

Fig 2: Removing ABS Module From HCU

Courtesy of FORD MOTOR CO.

Remove the ABS module from the HCU.

CAUTION: A new seal kit must be used when installing the ABS module. The old seals must be discarded as they may cause a leak between the ABS module and the HCU.

NOTE: The O-ring seals must be installed to the valve flange. Make sure there is no twist to the O-ring seal when installed.

Fig 3: Discarding O-Ring Seals And Installing New Ones

Courtesy of FORD MOTOR CO.

Discard the O-ring seals and install new ones (one seal per each valve stem).

NOTE: Clean the groove of the ABS module before installing a new seal.

Fig 4: Discarding ABS Module Sealing Material And Install A New Seal

Courtesy of FORD MOTOR CO.

Discard the ABS module sealing material and install a new seal.

CAUTION: All components must be free of dust, oil, fluid and foreign matter.

To install, reverse the removal procedure.